Sunrise Plastic Emulsion
Sunrise Plastic Emulsion formula cones with the silicon addition, making it a long lasting and easily washable superb finish paint. It provides excellent coverage with a pleasing silky smooth decoration of walls and ceilings . Our Plastic Emulsion comes in a variety of beautiful colours.
MAIN USES:
Recommended for the use in all rooms including kitchen and bathrooms on all types of interior masonry surfaces including plaster, concrete and brick work. It can also be used as an undercoat for Sunrise Synthetic Enamel on wood surfaces.
| COVERING CAPACITY | 11-15m2 / liter per oat (20-25 microns per coat) |
|---|
DRYING TIME
| Surface Dry | 30 minutes |
|---|---|
| Hard Dry | 1-2 hours |
| Recoatability | 1-2 hours |
| SOLID (VOL%) | 40 ‡ 2 |
| SPECIFIC GRAVITY | 1.40 - 1.60 |
THINNING::
Sunrise Plastic Emulsion requires thinning with clean water before use. The water should be added gradually with continued stirring. The amount of water to be added will depend upon the roughness and porosity of the surface and the rate of drying during application but the following is a general guide.
SURFACE PREPARATION:
New plaster, concrete, cement, brick work, etc: New surface should be allowed to dry out. If efflorescence or salts are present, they should be removed by wiping first with a dry coarse cloth and then with a damp cloth. The surfaces should be left for a time to see if any further efflorescence or slats appear. When efflorescence has ceased, putty if required then apply two or three coats of Sunrise Plastic Emulsion. CLEANINGS: Wash out brushes and rollers etc. immediately after use, a weak detergent solution or soap and water is suitable. Spots and splashes should be washed off before they have dried as Sunrise Plastic Emulsion is resistant to water and washing bocce it dire's.
PRECAUTIONS:
After use keep paint container air tight and store in a shady & dry place if paint spills on to your body or in your eyes, wash thoroughly with clean water.
