Sunrise Silky Emulsion
Sunrise Silky Emulsion is based on PVA copolymer binder which gives good flow and smooth matt finish.
MAIN USES:
Recommended for use on plaster, concrete, gypsum, brickwork and asbestos surfaces. This product is recommended for interior use only. Not recommended for metal surfaces.
COVERING CAPACITY | 11-15m2 / litter per oat (20-25 microns per coat) |
---|
DRYING TIME
Surface Dry | 30 Minutes |
---|---|
Hard Dry | 1-2 hours |
Recoatability | 1-2 hours |
Colour | STANDARD COLOUR RANGE |
FInish | Matt |
SOLID (VOL%) | 44 ‡ 2 |
SPECIFIC GRAVITY | 1.40 - 1.60 |
THINNING::
Use good quality white spirit to thin Sunrise Red Oxide Primer, as required for brush or spray application.
SURFACE PREPARATION:
All loose material including loose plaster, cement splashes, old paint, dust, dirt etc. must be thoroughly removed. New plaster/ concrete must be fully cured.
PRECAUTIONS:
After use keep paint container air tight and store in a shady & dry place if paint spills on to your body or in your eyes, wash thoroughly with clean water.
CLEANING:
Wash out brushes and rollers etc. immediately after use, a weak detergent solution or soap and water is suitable.
APPLICATION:
Before use, stir thoroughly to ensure that all the colorants are evenly mixed. For the first coat thin down 3.64 litters of Sunrise Silky Emulsion with 3.64 litters of Clean water under constant stirring. For subsequent coats 3 litters of water for 4 litters of Sunrise Silky Emulsion would be sufficient. Apply 2 to 3 coats by brush, roller or spray.
SURFACE PREPARATION:
New Surface
The surface should be dry and free from powdery material which can be done by rubbing with grinding stone or sand paper. Remove all the dust with water soaked cloth. Let it dry completely and apply one coat of Sunrise Primal-30. Allow the primer to dry hard overnight and sand paper it before applying Sunrise Special Emulsion.
Old Surface:
If the existing paint is sound, Sunrise Special Emulsion may be applied direct after normal cleaning. If the old paint is cracking or flaking remove the defective material by scraping. Dust off the surface and apply one coat of Sunrise Primal-30. When the primer is hard, apply 2 or 3 coats of Sunrise Special Emulsion.
