Sunrise Red Oxide Primer
Sunrise Red Oxide Primer is a high quality air drying anti-cori most suitable for metal surfaces as a base coat for air drying enamels.
MAIN USES:
On all interior and exterior steel surfaces to protect them against corrosive weathering conditions.
| COVERING CAPACITY | 11-13m°/ litter per oat (20-25 microns per coat) |
|---|
DRYING TIME
| Surface Dry | 2-3 Hour |
|---|---|
| Hard Dry | 24 hours |
| Recoatability | 16 hours |
| Gloss | Slight Sheen |
| SOLID (VOL%) | 55 ‡ 2 |
| SPECIFIC GRAVITY | 1.30 - 1.50 |
THINNING::
Use good quality white spirit to thin Sunrise Red Oxide Primer, as required for brush or spray application.
SURFACE PREPARATION:
Before application ensure the metal surface is absolutely free from rust, grease & welding flux, which can be achieved by wire brushing or sand papering and finally whipping with solvent soaked rag.
PRECAUTIONS:
After use keep paint container air tight and store in a shady & dry place if paint spills on to your body or in your eyes, wash thoroughly with clean water.
CLEANING:
Clean all equipment with mineral turpentine (MTT) immediately after use.
APPLICATION:
Apply one coat by brush. Let it dry for 20-24 hours, wet sand it with emery paper No. 320 and then apply the finish.
PRECAUTIONS:
Keep paint container air tight after use. Keep it away from open flame & heat. Where the painting is in progress ensure adequate ventilation.
