Sunrise Metallic Finish
Add an exotic look to your home with Sunrise Metallic Paint. When Sprayed on any surfaces its sparking mist will instantly electrify the appearance. Sunrise Metallic Paints give you subile transition from a plain dull appearance to an exotic sparking decor.
COLOUR RANGE:
Suitable for interior and exterior all metal, wood, plaster, brick, asbestos and concre. surfaces.Please realer to standard colour card, Customized shades available on request
COVERING CAPACITY | 13-15m / Lite / per coat |
---|---|
Hard Dry | 24 Hours |
SOLID (VOL%) | 46+2 |
Surface Dry | 10-15 minutes |
Hard Dry | 1-2 hours |
Recoatability | 12-18 hours (Depending on the humidity and temperature) |
Packing | 3.64 Litres 0.91 Litre |
THINNING:
Sunrise Special Emulsion requires thinning with clean water before use. The water should be added gradually with continued stirring. The amount of water to be added will depend upon the roughness and porosity of the surface and the rate of drying during application
APPLICATION:
Please stir thoroughly before applying to ensure even pigmentation. Thin it down with good quality white spirit to desired application visessity for brushing and spray apply two coats of Sunrise Metallic Finish for best results between coats allow 12 to 18 hours under normal weather conditions.
PRIMING:
An appropriate Champion Primer is available for most types of surfaces. Primer should always be applied by brush.
SURFACE PREPARATION:
Preparation of the surface is the most important step in painting and greatly affects the life and appearance of paint. Sunrise Metallic Finish paint should be applied following the priming. For smoothing out rough surfaces our where the colour of finish has changed appreciably, use of undercoat white/grey is recommended. For maximum durability, apply Sunrise Metallic Finish direct to primer. Previously unpainted surfaces must be thoroughly cleaned before painting. Rust, Mil , Scale, Oil, Dust and grease may be removed by abrasive paper or white spirit. Old work, in a bad condition ( blistered, flaked, cracked, or powdery) must be burnt off or stripped with paint remover. After cleaning apply one coat of Sunrise Undercoat and drying apply two coats of Sunrise Metallic Finish. For wood all knots and resinous patches should be treated. In case to bright and new metal surfaces such as galvanized iron or aluminium rub it down with fine sand paper and clean with white spirit so that paint may not flake off.
TIPS FOR SAFETY, ECONOMY AND ENVIRONMENTAL PRETECTION:
Keep the paint away from sources of ignition and avoid smoking. Where the Painting is in progress ensure adequate ventilation.
